Header

SwitchME4 DALI

Analog - DALI compatible relay


The SwitchME4 DALI 4CH relay is a DALI compatible relay. Device designed to allow for the independent switching of four devices (luminaires and others) through a DALI interface.
On the front panel of the device can be found an integrated push button for the manual control of the relays for testing purposes, additional to five device status indicator LEDs.

The device is housed in a standard DIN-rail mountable box for easy installation in electrical switchboards.



SwitchME4 DALI

Functions


After powering-up the device an internal test sequence is initiated that lasts for no more than two seconds. The device then acts in normal mode and awaits DALI commands.

The "STATUS" LED indicator is lit when the DALI BUS is correctly supplied. LED indicators one to four show the current status of each relay:
a lit LED means the corresponding relay is switched on, an unlit LED means the corresponding relay is switched off.



Test mode

  •    Test mode can be activated at any time by pressing the push button "TEST"
  •    A short push of the button, for a period less than three seconds, changes which relay is selected, indicated by the corresponding LED indicator blinking
  •    By pressing the push button for a period of more than three seconds the selected relay is switched on / off, indicated by the way in which the LED indicator blinks (predominantly on means the relay is switched on, predominantly off means the relay is switched off)
  •    The device will return to normal mode after five seconds of push button inactivity


  • Technical data


       KEY FEATURES

    Four independent relay contacts
    12 A maximum switching current per contact
    Push button for manual control (test function)
    One DALI address for each contact (DALI device type 7, EN 62386-208)


       PHYSICAL CONNECTIONS

    Mains cable wires: AWG 24 - 12 (0.2 - 2.5 mm²)
    DALI cable wires: AWG 28 - 16 (0.08 - 1.5 mm²)
    Relays cable wires: AWG 24 - 12 (0.2 - 2.5 mm²)


       CONSTRUCTION

    Housing: 4U DIN rail box, 71 mm wide
    Weight: 300 g
    IP rating: IP 20

       CERTIFICATION

    EN 55015 Limits and methods of measurement of radio disturbance characteristics of electrical lighting and similar equipment
    EN 61547 Equipment for general lighting purposes EMC immunity requirements
    EN 60950-1 I Information technology equipment - Safety - Part 1: General requirements
    EN 62386-208 Digital addressable lighting interface


       ENVIRONMENTAL CONDITIONS

    Operating temperature range from 0 ºC up to 40 ºC
    Relative humidity 85 % max., non-condensing
    Storage temperature range from -40 °C up to 70 °C


       POWER

    Mains supply: 220 - 240 VAC / 50 - 60 Hz
    Max. system power: 6 W
    DALI consumption < 2 mA
    Relay loads: 12 A (per contact)
    Insulation: 4 kV






    preussen automation GmbH

    Flurweg 11
    82402 Seeshaupt
    Germany

      +49 (0) 8801 / 91 19 - 030
      +49 (0) 8801 / 91 19 - 013
      service@preussen-automation.eu


    ARIBA Discovery

    Profile of eventa AG

    Profile of eventa AG in Ariba Discovery anzeigen